Digital Control Engineering

Professor and Chair of Department of Electrical & Biomedical Engineering, College of Engineering, University of Nevada, Reno, NV, USA. M. Sami Fadali earned a BS in Electrical Engineering from Cairo University in 1974, an MS from the Control Systems Center, UMIST, England, in 1977 and a Ph. D. from the University of Wyoming in 1980. He was an Assistant Professor of Electrical Engineering at the University of King Abdul Aziz in Jeddah , Saudi Arabia 1981-1983. From 1983-85, he was a Post Doctoral Fellow at Colorado State University. In 1985, he joined the Electrical Engineering Dept. at the University of Nevada, Reno, where he is currently Professor of Electrical Engineering. In 1994 he was a visiting professor at Oakland University and GM Research and Development Labs. He spent the summer of 2000 as a Senior Engineer at TRW, San Bernardino. His research interests are in the areas of fuzzy logic stability and control, state estimation and fault detection, and applications to power systems, renewable energy, and physiological systems Full Professor in Control Systems at the Department of Mechanical and Industrial Engineering of the University of Brescia, Brescia, Italy He received the Laurea degree in Electronic Engineering from the University of Parma in 1995. From September 1994 to February 1995 he was an ERASMUS student at the Electrical and Electronic Department of the Loughborough University of Technology (now Loughborough University), UK. From September 1995 to November 2012 he was with the Department of Information Engineering (formerly, Department of Electronics for Automation) of the Faculty of Engineering of the University of Brescia . In 1999 he received the Ph.D. degree in Applied Mechanics from the University of Brescia. He is a senior member of IEEE, a member of the IFAC Technical Commitee on Education, a member of the Technical Committee on Education of the IEEE Control Systems Society, a member of the subcommittees on Event-Based Control & Signal and on Industrial Automated Systems and Control of the IEEE Industrial Electronics Society Technical Committee on Factory Automation, and a member of the national board of Anipla (Italian Association for Automation).

1. Introduction to Digital Control 2. Discrete-Time Systems 3. Modeling of Digital Control Systems 4. Stability of Digital Control Systems 5. Analog Control System Design 6. Digital Control System Design 7. State–Space Representation 8. Properties of State–Space Models 9. State Feedback Control 10. Optimal Control 11. Elements of Nonlinear Digital Control Systems 12. Practical Issues

APPENDIX I: Table of Laplace and z-Transforms II: Properties of the z-Transform III: Review of Linear Algebra