Advances in Carbon Management Technologies -

Advances in Carbon Management Technologies

Carbon Removal, Renewable and Nuclear Energy, Volume 1
Buch | Softcover
452 Seiten
2022
CRC Press (Verlag)
978-0-367-53364-9 (ISBN)
83,50 inkl. MwSt
This book was motivated by the desire to compile recent advances in carbon management to examine promises and limitations of emissions measurements, energy efficiencies, carbon capture and sequestration, biomass waste utilization, electric power generation, energy storage, and carbon neutral power from nuclear, hydro, solar and wind.
Advances in Carbon Management Technologies

comprises 43 chapters contributed by experts from all over the world. Volume 1 of the book, containing 23 chapters, discusses the status of technologies capable of yielding substantial reduction of carbon dioxide emissions from major combustion sources. Such technologies include renewable energy sources that can replace fossil fuels and technologies to capture CO2 after fossil fuel combustion or directly from the atmosphere, with subsequent permanent long-term storage. The introductory chapter emphasizes the gravity of the issues related to greenhouse gas emissionglobal temperature correlation, the state of the art of key technologies and the necessary emission reductions needed to meet international warming targets. Section 1 deals with global challenges associated with key fossil fuel mitigation technologies, including removing CO2 from the atmosphere, and emission measurements. Section 2 presents technological choices for coal, petroleum, and natural gas for the purpose of reducing carbon footprints associated with the utilization of such fuels. Section 3 deals with promising contributions of alternatives to fossil fuels, such as hydropower, nuclear, solar photovoltaics, and wind.

Chapter 19 of this book is freely available as a downloadable Open Access PDF at http://www.taylorfrancis.com under a Creative Commons Attribution-Non Commercial-No Derivatives (CC-BY-NC-ND) 4.0 license.

Subhas K Sikdar retired as Associate Director for Science, National Risk Management Research Laboratory of USEPA. Earlier he held technical and managerial positions at Occidental Research Corp, National Institute of Standards and Technology, and General Electric Corporate Research & Development Center. Dr. Sikdar is an elected Fellow of AAAS, ACS, AIChE, IIChE, and winner of EPA bronze medals, R&D 100 awards, several national awards from AIChE, and distinguished achievement awards from EPA, University of Arizona, and University of Calcutta. He is Editor-in-Chief of Clean Technologies and Environmental Policy (Springer), and serves as a member of the conference committee of Engineering Conferences International. He has edited 16 books. Frank Princiotta recently retired as Director of the Air Pollution Prevention and Control Division of the Office of Research & Development, Environmental Protection Agency. He has a degree in Chemical Engineering from City University of NY (Tau Beta Pi, Omega Chi Epsilon) and a Nuclear Engineering Certificate from the Oak Ridge School of Reactor Technology. His division is responsible for RD & D on technologies for controlling and characterizing air pollution from major sources. He has been a key agency expert in air pollution control for over 40 years. He has been the recipient of an EPA gold medal, and three bronze medals for his accomplishments in the air pollution control field. He has also received the President’s Meritorious Executive Award on two separate occasions (Presidents Carter and H.W. Bush). He played the leadership role in the development and demonstration of sulfur dioxide pollution control technology for coal-fired boilers, which has been the mainstay of SO2 control worldwide. An author of many scientific papers on air pollution control, he has been a frequent speaker before technical societies and conferences and has testified before Congressional Committees. In recent years he has focused on mitigating global climate change. He has analyzed the role that technology and cultural changes will need to play, if we are to avoid the potentially catastrophic impacts associated with unconstrained use of energy.

Introductory. What key low-carbon technologies are needed to meet serious climate mitigation targets and what is their status. SECTION 1. GLOBAL AND REGIONAL VIEWS OF CARBON MANAGEMENT. Introduction. Removing greenhouse gases from the air to stabilize the climate. Low carbon technologies in global energy markets. Carbon Management: forest conservation and management. Reducing carbon footprint of products (CFP) in the value chain. Significance of GHG measurement on carbon management technologies. SECTION 2. FOSSIL SECTOR: COAL/PETROLEUM/NATURAL GAS. Carbon policies for reducing emissions in power plants. Carbon mitigation in the power sector: challenges and opportunities. The environmental impact of implementing CO2 capture process in power plants: effect of type of fuel and energy demand. Systems integration approaches to monetizing CO2. Energy-water-CO2 nexus of fossil fuel-based power generation. Natural gas reforming to industrial gas and chemicals using chemical looping. Alternative pathways for CO2 utilization via dry reforming of methane. Ranking carbon emissions mitigation options under uncertainty. Carbon management in the CO2-rich natural gas to energy supply chain. Coal to chemicals: a smart choice. Optimal planning of biomass co-firing networks with biochar-based carbon sequestration. Trends in transportation greenhouse gas emissions and implications for carbon management. SECTION 3. WIND/SOLAR/HYDRO/NUCLEAR. Nuclear energy and carbon emission reduction - promise and problems. Concentrated solar energy driven multi-generation systems based on the organic Rankine cycle technology. Solar photovoltaic technologies and systems. Reducing the Carbon Footprint of Wind Energy: What Can Be Learned from Life-Cycle Studies? Hydropower.

Erscheinungsdatum
Zusatzinfo 103 Tables, black and white; 8 Illustrations, color; 188 Illustrations, black and white
Verlagsort London
Sprache englisch
Maße 178 x 254 mm
Gewicht 1147 g
Themenwelt Technik Bauwesen
Technik Umwelttechnik / Biotechnologie
Weitere Fachgebiete Land- / Forstwirtschaft / Fischerei
ISBN-10 0-367-53364-2 / 0367533642
ISBN-13 978-0-367-53364-9 / 9780367533649
Zustand Neuware
Haben Sie eine Frage zum Produkt?
Mehr entdecken
aus dem Bereich
Grundlagen und Vorgehensweisen

von Bernd Kochendörfer; Jens H. Liebchen; Markus G. Viering

Buch | Softcover (2021)
Springer Fachmedien Wiesbaden GmbH (Verlag)
37,99
Bemessung von Stahlbauten nach Eurocode mit zahlreichen Beispielen

von Jörg Laumann; Christian Wolf

Buch | Hardcover (2024)
Springer Vieweg (Verlag)
59,99
Kommentar zu VOB/C ATV DIN 18340, ATV DIN 18299

von Volker Mänz; Thomas Schmid; Markus Weißert

Buch | Softcover (2024)
DIN Media (Verlag)
69,00